Location:Home > Knoledge

Knoledge

Want to make the machine start. How to do?

发布日期:2013/7/27 9:42:52阅读次数:字号:

Answer: recommend steps to let the operation of the machine tool parts. If you want to in the original switch, limit switch, emergency stop button is not yet connected to the machine start, the steps are as follows:

The software limit input, emergency stop input polarity is set to "N", namely the normally open input, so that in the absence of pick up these signals will not alarm;

The DC24V supply power to the terminal board. Because the drive also need 24Vpower supply;

The 10 set of servo drive;

The feed rate low, try manual movement of machine tool. If the Z axis using a servo motor with brake, don't let the Z axis motion, according to question 16, 17, 18connected brake.